Best way to remove paint from wooden windows

Link to Amazon from here. Using an infrared heat paint stripper. Using an infrared heat paint stripper to remove old glazing. The triangle scraper is the best, but a good quality one can be hard to find. Hold the heater above the glass to help unstick the glass from the glazing.

Window coated with an epoxy consolidant waiting to have its holes filled with an epoxy filler. Corner of window painted with the epoxy consolidant. Epoxy filler add to make new corner. Note that the filler is larger than the finished corner so it can be sanded down to actual size. Finished corner. Again, a heat gun on high also can be used. Average time to do the above work is one hour per six pane window Once the old glazing is removed as well as the glass, scrape the mullions with the triangular scraper to remove any glazing or old paint.

Sand the window pane to create a smooth surface. Use a manual sander with grit sandpaper to work away any small scrapes and remove any tiny flecks of paint that remain. Question 8. Lay down a tarp and put on your protective gear. Use a tarp or a drop cloth to cover the ground beneath the window to protect the floor from the paint stripper. Put on rubber gloves, goggles, and a respirator before you start working.

Tip: Wear long sleeves and pants to protect your skin from spills and drips. Some products will have longer curing times than others, which might affect your decision. Apply the paint stripper to the metal window frame and let it sit. Apply as thick of a coat of the stripper as you can without having it drip down the frame. Leave the stripper alone to do its work, which usually takes about 20 to 30 minutes.

Scrape away as much of the paint as possible. Use a paint scraper or a nylon brush or scrubbing pad to chip away the peeling paint. If there is more dried paint underneath the first layer, reapply the stripper and repeat the scraping process as many times as needed until the metal is exposed.

Rinse the window frame and then dry it off with a clean rag. Dip a clean rag into water and thoroughly wipe down the window frame to remove any remnants of paint thinner or mineral spirits. After that, take a clean, dry rag and dry off the frame completely. Whether you have a lot of paint or a little, you can use a scraper to loosen the paint from the glass. Use one that takes a single-edge razor blade, which can be bought for a few dollars at a general or hardware store.

Remember to keep the blade as flat as possible against the glass. Take special care when scraping around the edge of the window where the frame is -- you don't want to cut the frame or the caulk that goes between the pane of glass and the frame. When you have loosened all the paint, you can remove the loose bits by wiping with a dry cloth. Then clean all the window panes with a little glass cleaner such as Windex and finish off with a dry lint-free cloth.

Not Helpful 1 Helpful 6. If the paint stains become soft, it is easy to remove them. Now the question is, how do I soften the hard and stubborn paint stains from the glass? Use a hair dryer. Heat one area at a time, then use a utility knife box cutter to gently remove the paint.

Do NOT press too hard, or you will scratch the glass. You can also use a kitchen knife. Wipe with a soft dry cloth, then move on to the next stain. Don't forget to feel for any remaining bumps.

If you detect any, remove them the same way. Not Helpful 0 Helpful 1. Spray Easy-Off oven cleaner, which removes oil and paint. Do not breath the Easy-Off spray, because it's pH burns the lungs. Open all the windows and run outside for a few minutes after spaying the Easy-Off oven cleaner on the windows.

Use Windex and a roll of paper towels to clean the paint and Easy-Off from the window. Not Helpful 0 Helpful 0. Sarah Battilana. If the tape won't simply peel off, you can use the same method as removing paint from glass. Get the tape wet with boiling white vinegar, and rub the tape until it starts to peel off. Use something like goo-be-gone to remove any remaining sticky residue. Include your email address to get a message when this question is answered.

Never try to scrape away paint when it is dry. You need to use some kind of lubrication to avoid scratching the glass or gouging out chunks of wood. Helpful 0 Not Helpful 0. You Might Also Like How to. How to. Window Cleaning Specialist. Expert Interview. More References About This Article.

Co-authored by:. Co-authors: Updated: December 4, Categories: Window Cleaning. Article Summary X To remove paint from window glass, start by heating 1 cup of white vinegar in the microwave for seconds. Place a drop cloth around the base of the window.

Dip a small brush into an open can of stripper. Starting on one side at the top, paint the window frame with a liberal coat of stripper. Work your way around the frame until all exposed areas are covered. Wait 15 minutes. Hold the tip of a putty knife at a degree angle against the frame where you started with the stripper. Using a moderate amount of force, push the edge of the putty knife along the frame.

The paint softens into a gel and the putty knife will slide underneath it. When the paint builds up on the knife, let it drop off the knife onto the cloth. Scrape the paint off the entire frame.